2020 run full home gigabit network $200 soft router + AP A set of solutions

My device in the picture:
AP: Fusion K3 D1 version, official change firmware ($400)
Bypass Routing: N1 Box ($139)
Dual male USB cable (for N1 downgrade)
HDMI cable (for N1 to monitor)
USB flash drive (for N1 brushing)
200 program:
Wireless AP: Barley DW33D (Idle Fish, $80)
Soft Routing: N1 Box
Text version:

in the first placeTo know the static intranet IP of your APsAddress.For example, many routers are 192.168.1.1As its staticIP

clotureDHCPfunctionality

• • • Get the N1.(math.) genusnetwork cableConnect your computer.HDMIConnect the monitor, then connect thePower supply (Powered By::U97F3)
    • press Ctrl-Alt-DeleteViewN1Firmware version number, greater than2.19The firmware should be downgraded before flashing, and the downgrade needs to be connected to thedual male line
    • relegateConnect it.dual male lineThe first step is to brush the downgrade package with the [Downgrade Tool].
    • Use your computer to write the system intoUclassifier for coils of wireWith [Etcher], putOpenWRT(hereinafter referred to asOP(or other system image files) flashed into theUclassifier for coils of wire

• • • set upUdisk driveWith [N1activationUDisk Boot Utility] allowsN1Priority useUThe disk boots (actually, it boots through theip sshuntil (a time)N1Then use theadb(change of start-up sequence)
    • take part inUclassifier for coils of wireReboot.N1(reboot), reboot and enter theOpenWRT

• • • expense or outlayUThe system on the disk (OP(or other), flashing the system into theN1Local storage (EMMC)

• • • configureN1Pull outUAfter disk brushing is complete, unplug theUDisk, restart (reboot)N1This is when you enter theN1Your own system that you've brushed up on.OP(or other)

• • • UThe disk has been pulled out.
    • HDMIWire to the monitor
    • N1to your computer with a network cable using the single network port of the

• • • reticulation - connector - Lanmouth - Modify theLanmouthIPV4The address is changed to the same address as theAPThe same network segment (e.g.APStatic intranet address:192.168.2.1Well, at first.N1The static network address of the192.168.1.1I've got to putN1(used form a nominal expression)LANmouthIPV4Change the address to192.168.2.2or other192.168.2.XXXaddress)
    • reticulation - connector - Lanmouth - Modify theLanmouthDNSThe server and gateway are all filled in asAPThe static network address, which is very important, was not filled in by me because I did not fill in theDNSserver isAPStatic intranet address, got it until 3am, hence this post to summarize the pitfalls
    • reticulation - connector - Lanmouth - Modification, the followingDHCPIf you click on the second tab, check the "Force" box to force the use of theN1act asDHCPserver (computer)
    • reticulation - firewalls - Customize the rules to add an article:

• • groutN1together withAP(My)APbeK3).AP(used form a nominal expression)WANport to an optical cat or a network cable connected from outside.AP(used form a nominal expression)LANport andN1The single network port of the device is connected, reboot everything, and wait for it to boot up, then you can configure Science♂ to access the Internet